Standby Generator Sizing for Canadian Homes
A useful generator size comes from the loads your household needs during an outage, how those loads start and overlap, and what the site can safely support—not from floor area alone.
Begin with an outage plan
List what must operate, what would be helpful, and what can remain off. Canadian homes often prioritize heating controls and fans, sump or well pumps, refrigeration, lighting, communications, medical equipment, and selected receptacles. Homes with electric heat, heat pumps, pumps, or large motors need particular care because demand can change sharply as equipment starts. The broader generator sizing page explains essential-load, managed whole-home, and fuller-coverage strategies.
Record running and starting loads
Running watts describe steady operation; starting demand captures the brief surge from motors and compressors. Record equipment nameplate information and the circuits supplying each load, but do not treat a simple nameplate total as the final calculation. A qualified electrical professional must confirm the calculation, simultaneous demand, service arrangement, transfer equipment, and final generator selection.
Account for fuel and Canadian conditions
Natural-gas pressure and volume must support the generator while other appliances may also operate. Pipe length, meter and regulator capacity, connected appliance demand, elevation, and manufacturer derating information can change available output. Cold, snow, ice, wind, and winter access also affect selection and placement. Review installation planning before choosing equipment.
Plan load management and future demand
Load-management controls can delay or shed large appliances so priority circuits remain available. Discuss likely additions such as a heat pump, hot tub, workshop equipment, or EV charging before design is finalized. Undersizing may overload a system; unnecessary oversizing can add fuel demand and complexity without improving the outage plan.
Prepare a contractor-ready worksheet
Gather service and panel ratings, a major-equipment list, outage priorities, gas meter information, possible placement, approximate routing, and future-load plans. Note any well, sump pump, sewage equipment, or electrically dependent heating. Use this record with appropriately licensed gas and electrical professionals; requirements and approvals vary by site and jurisdiction.