Canadian standby power guide

How an Automatic Transfer Switch Works

An automatic transfer switch, or ATS, coordinates the safe change between utility and generator power. It is a core safety and control component, not simply an accessory.

What happens when utility power fails

The controller monitors the utility supply. After it confirms that voltage or frequency is outside acceptable limits for a programmed interval, it signals the generator to start. A short delay helps avoid starting for a momentary disturbance. Once generator output is stable, the switch can transfer the connected loads.

Isolation prevents backfeed

Before connecting generator power, the ATS disconnects the utility source. This interlocked operation prevents improper source connection and protects utility workers, occupants, and equipment. Never connect a generator to building wiring through an improvised connection. Electrical design and work must be completed by an appropriately licensed electrical professional.

The load arrangement matters

An ATS may serve an essential-load panel, a service-rated whole-home arrangement, or part of a complex commercial system. Its current rating, poles, neutral treatment, service-entrance rating, enclosure, fault-current suitability, and controls must match the site-specific design. Load management may keep large appliances from operating together.

Returning to utility power

When stable utility power returns, the controller waits through a retransfer delay, switches loads back to the grid, and lets the generator cool before stopping. Timing and exercise settings vary. Periodic transfer testing is more informative than a no-load exercise alone, but tests should be coordinated to avoid operational risk.

Questions to resolve before installation

Confirm which loads transfer, where the switch can be safely installed and serviced, whether utility or metering work is involved, and how gas supply, controls, permits, and commissioning are coordinated. See the installation guide for the full sequence. Site-specific requirements vary, and gas and electrical work must be completed by appropriately licensed professionals.

← View all generator guides

Turn outage priorities into a project brief.

Start the conversation